Robustrack distributes a full range of aluminium loading ramps designed and produced in Italy to fit any type of excavators from 0.8 to 10 Ton. Supplied in 2.5m – 4.5m length as standard but special sizes made on request.
Description
Robustrack distributes a full range of aluminium loading ramps designed and produced in Italy to fit any type of excavators from 0.8 to 10 Ton. 2.5m – 4.5m length as standard but special sizes made on request.
Our loading ramps are manufactured utilising the best aluminium alloy EN_AW 6005/A and follow European certification guidelines. The are ideal for loading and unloaded vehicles on and off trailers as required.
We offer various models of ramps with different carriage widths (H100 – H190).
Each ramp is made up of
-lateral side spars
-plates fixed to the loading bed anchoring system.
Ramp length is strictly relative to angle or slant. Before use, operators need to consider this fundamental: the slant must not exceed the max slant of 30% that is 16.5°.
Therefore, so as to establish the minimum length to use, to exceed the maximum slant, the operator must apply the following formula (valid for loading operations on normal, flat ground).
To load a digger on a truck 1.2m high you will need ramps at least 4m long with an angle of 30% (1.2 x 100/30 ).
The width of the ramps and the size of the spars define the loading capacity in terms of weight of each ramp. Our Sales team are available to assist in finding the right ramps for your requirements.
